Fortigate ipsec configuration

The following section consists of configuring the FortiGate unit and configuring the Cisco router. Adding policies on FortiGate 1. In a fully-redundant VPN configuration with two interfaces on each peer, four distinct paths are possible for VPN traffic from end to end. Select the Site to Site template, and select FortiGate. In the Authentication step, set IP Address to the IP of the HQ FortiGate (in the example, 1722).

The remote user Internet traffic is also routed through the FortiGate (split tunneling will not be enabled). How to configure forticlient VPN? Typically, when a FortiGate unit runs in transparent mode, different network segments are connected to the FortiGate interfaces. By default, FortiGate provisions the IPSec tunnel in route-based mode. This topic focuses on FortiGate with a route-based VPN configuration.

If necessary, you can have FortiGate provision the IPSec tunnel in policy-based mode. To enable the feature, go to System, and then to Feature Visiblity. The tunnel name cannot include any spaces or exceed characters.

IPsec VPN with FortiClient. Set Template to Remote Access, and set Remote Device Type to FortiClient VPN for OS X, Windows, and Android. Select Finance_network when configuring FortiGate _1. Select HR_network when configuring FortiGate _2. The address name for the private network behind this FortiGate unit.

The Fortinet Cookbook contains examples of how to integrate Fortinet products into your network and use features such as security profiles, wireless networking, and VPN. Outgoing Interface: Select peer_1. Using the Cookbook, you can go from idea to execution in simple steps, configuring a secure network for better productivity with reduced risk. HQ set interface wanset peertype any set proposal aes128-sha2aes256-sha2aes128-shaaes256-shaset remote-gw 22. HQ set phase1name to_HQ set proposal aes128-shaaes256-shaaes128-sha2aes256-sha2aes128gcm aes256gcm.

Transport mode is used instead of tunnel mode. The encryption and authentication proposals must be compatible with the Microsoft client. A Japanese translation is included as a PDF attachment at the end of this article. Components : All FortiGate units running FortiOS 3. Steps or Commands : Configure FortiGate. Set Up IPSec Site to Site VPN Between Fortigate 60D (3) - Concentrator and Troubleshooting Set Up IPSec Site to Site VPN Between Fortigate 60D (4) - SSL VPN Fortigate firewall supports two types of site-to-site IPSec vpn based on FortiOS Handbook 5. FortiGate (Site A) To NAT the traffic entering the IPSec tunnel with a specific IP address, a policy-mode IPSec tunnel can be created with the following configuration : 1. Hi, i created a site to site vpn with a 4g router on each side and the fortinet router linked to it however the two fortinet routers can be seen since the vpn is up but the ping does not work.

Both fortinet have the same configuration. I post you the fortinet conf image. IPSEC vpn with SD-WAN We are new Fortigate users and switching from Sonicwall firewalls.

Now you have learned about to setup Client-to-Site IPSec VPN using Fortigate.